How to make meth at home…
List of chemicals and materials:
Diluted HCl – also called Muriatic acid – can be obtained from hardware stores, in the pool section
NaOH – also called lye
Ethyl Ether – aka Diethyl Ether – Et-0-Et – can be obtained from engine starting fluid, usually from a large supermarket. Look for one that says “high ethyl ether content”, such as Prestone
Ephedrine The cottons in todays vicks nasle inhalers dont contain efed or pfed (ephedrin or psuedoephedrin) but there are still lots of easy ways to get good ephed or pfed, pure ephedrin can be extracted out of it’s plant matter, from a plant that can be bought at most garden stores. Or you can get pfed from decongestive pills like sudafed. Most people perfer to work with pfed from pills rather then ephed from the plant. The important thing is that you must have pure pfed/ephed as any contaminants will fuck up the molar ratio leaving you with over-reduced shit or under-reduced shit. Or contaminats will jell durring baseifying and gak up your product which will then be very hard to clean. So you want to find a pill that is nearly pure pfed hcl, or as close to pure as you can get. Also check the lable on your pills and see what inactive ingredients they contain. Inactive ingredients are things like binders and flavors. These you dont want and will remove when cleaning your pills. but certain inactive ingredients are harder to remove then others. You dont want pills with a red coating, you dont want pills with alot of cellose in them and you dont want pills with much wax. you also dont want pills that contain povidone. As a rule, if you have a two pills that contain the same amount of pfed hcl then take the smaller sized pill because it obviously has less binders and inactive ingredients, time released pills are usualy harder to work with because they have more binders and tend to gel up durring the a/b stage. Also only buy pills that have pfed hcl as the only active ingredient. You first have to make ephedrine (which is sometimes sold as meth by itself):If you are selling it…I would just make ephedrine and say it’s meth.
Distilled water – it’s really cheap, so you have no reason to use the nasty stuff from the tap. Do things right.
List of equipment :
A glass eyedropper
Three small glass bottles with lids (approx. 3 oz., but not important)one should be marked at 1.5oz, use tape on the outside to mark it (you might want to label it as ether). One should be clear (and it can’t be the marked one).
A Pyrex dish (the meatloaf one is suggested)
A glass quart jar
Sharp scissors
Clean rubber gloves
Coffee filters
A measuring cup
Measuring spoons
Preparing your Lab:
Preparing Ethyl Ether:
WARNING: Ethyl Ether is very flammable and is heavier than air. Do not use ethyl ether near flame or non-sparkless motors. It is also an anaesthetic and can cause respiratory collapse if you inhale too much.
Take the unmarked small bottle and spray starter fluid in it until it looks half-full. Then fill the rest of the way with water, cap the bottle and shake for 5 minutes. Let it sit for a minute or two, and tap the side to try and separate the clear upper layer. Then, draw off the top (ether) layer with the eyedropper, and throw away the lower (water) and cloudy layer. Place the ether in the marked container. Repeat this until you have about 1.5 oz. of ether. Put the cap on it, and put it in the freezer if you can. Rinse the other bottle and let it stand.
Ethyl ether is very pungent. Even a small evaporated amount is quite noticeable.
Ephedrine & or P-Ephedrine: Will continue…
2 thoughts on “Making Methamphetamine at home”